Why Does My Clothes Dryer Vent Tube Keep Clogging?

Dryer

On more than one occasion, in the course of performing a home inspection, I’ll require the homeowner when they truly are having trouble with their clothes dryer of course, if it appears to take very long to dry their clothes. Most of the time that they look astonished and inquire how I could know that. I’m told that the dryer started out fine then simply appeared to take longer and more to completely wash the clothes, and they’re on the edge of calling a tech or buying a new appliance. Then I take them out and reveal them the dangerous condition that exists and the cause of the situation… a drier vent tube that is totally clogged with lint at the tube.

Does this illness stop the appliance fromĀ dryer vent cleaning drying correctly, it is a severe fire hazard. I then suggest to them the main reason behind your clog – a screen installed on the end of the exhaust hood. “This screen isn’t supposed to be there”, I let them know “rather than only is it a fire danger, however it’s against building code”. To make matters even worse, they tell me they previously brought up the problem with their builder, also was told that the screen is needed to help keep”critters” from entering. Just what a completely incorrect statement. This averts any critter entrance.

Possessing a screen, of any type, on the conclusion of the vent tube is good for just one item… stopping lint from venting and inducing a clog within the full tube, period”. Anybody who claims otherwise is oblivious to the potential hazard as well as the code. Screens will not be installed at the duct termination. Ducts shall not be attached installed using sheetmetal screws or other fasteners that may block blood flow. Clothes dryer exhaust ducts will not be connected into a gas vent connector, either gas vent or chimney.

There are many others which are just as ignorant concerning the code requirements. Within a new stucco review, I’d like to notice that a badly clogged port hood. I asked the homeowner my standard question concerning their drier and has been told the the tube blocked frequently. They had it washed out two before, and so were getting ready to have it done a third time. The company they used never said the screen on the end of the tube. I’d like to think that it was just an oversight instead of conveniently over looked for job security.

I also noticed my neighbors’ newly installed roofing with a new spanking new vent hood installed. Need less to say it was the wrong type and may not have already been used for a clothes dryer vent. And guess what, it was starting to clog and the roof company would not repair it.

The Consumer Products Safety Commission estimates there are 24,000 clothes dryer fires annually in the USA, amounting to $96,000,000 in estimated property damage. Lack of care and improper installments would be the major causes, and LINT could be your top material to spark. These fires can be brought on by collapse of mechanical and/or electrical parts within the drier itself, improper substances being placed to the drier, and also insufficient airflow as due to improper installation.

A regular inspection of your dryer components and installation material should be performed included in routine homeowner maintenance. Make sure you check your dryer vent and hose hose regularly for lint accumulation, also make sure there isn’t any monitor on the ending of the tube. If the tube ends in your roof, make sure to have a professional inspect the end to get a screen in case you’re not comfortable going on the roofing.

No comments yet

leave a comment

*

*

*